Walton Primo Flashing Guide
How to Flash Walton Primo? – Flashing a smartphone refers to the process of installing or updating the device firmware, which can serve various purposes, such as operating system upgrades, fixing software issues, or even unlocking additional functions. This guide is specifically tailored for Walton Primo models GH6+, H9, and S6. Before proceeding with flash instructions, please note that flashing a device can be risky and may void the warranty. Ensure to follow all steps carefully.
Before You Begin:
- Charge your Walton Primo device to at least 50-60% to avoid accidental shutdown during the flashing process.
- Back up all important data from your device to a secure location as flashing will erase all data from the device.
- Download the correct firmware for the specific model you are aiming to flash (GH6+, H9, or S6).
- Have a reliable USB cable on hand for connecting your device to your computer.
Tools Required: (How to Flash Walton Primo?)
- SP Flash Tool (Smart Phone Flash Tool)
- MediaTek USB VCOM drivers
- Firmware file for your specific Walton Primo model
Flashing Steps:
1. Download and Install the Necessary Tools:
- Download SP Flash Tool and extract it on your computer.
- Install MediaTek USB VCOM drivers to ensure your computer correctly communicates with the device.
2. Preparing Firmware:
- Download the appropriate firmware for your Walton Primo model from a trusted source.
- Unzip the downloaded firmware file to a folder on your computer.
3. Launch SP Flash Tool:
Open the folder where the SP Flash Tool is extracted and locate the `flash_tool.exe` file. Run it as an administrator.
4. Loading the Firmware:
- In the SP Flash Tool interface, click on the “Scatter-loading” button.
- Navigate to the firmware folder and select the scatter file (It has a `.txt` extension).
5. Initiating Flash Process:
- Before connecting your phone to the computer, remove the battery if possible. If the battery is non-removable, ensure the device is turned off.
- Click on “Download” in the SP Flash Tool.
- Connect your Walton Primo to the computer using the USB cable. If the battery was removed, reinsert it at this point.
6. Flashing the Device:
- The tool will automatically begin the flashing process once the device is detected.
- A progress bar will indicate the flashing status. Do not disconnect your device or interrupt this process.
7. Completion:
- Upon successful flashing, a green circle will appear on the screen.
- Disconnect your device and turn it on. The first boot may take a bit longer than usual.
8. Setup Device:
If the device boots up to the setup screen, proceed with the device setup. If not, retry the flashing process or seek professional help.
Troubleshooting Tips:
- Device not detected: Make sure MediaTek USB VCOM drivers are installed properly.
- Error during flashing: Check if you have selected the correct scatter file and firmware version.
- Bootloop after flashing: Perform a factory reset in the recovery mode of your Walton Primo.
Disclaimer:
Flashing firmware can be a complex process that carries a risk of bricking your device. People should only try it if they know what they’re doing or under professional guidance. The responsibility of following this guide lies entirely with the individual, and any damage to the device as a result of following these instructions is not the responsibility of the content creator.
Always stay patient during the process and avoid any operations not mentioned in the guide. Follow these steps carefully for a successful update or repair of your Walton Primo device.
